BENDIX SD-08-2418 Manuel d'utilisateur télécharger pdf (Page 11)

ASSEMBLY

1. Lubricate the smaller o-ring and check valve body with

a heavy duty lithium grease.

2. Install this o-ring on the check valve body by sliding the

o-ring over the set of four tapered guide lands. The

o-ring groove holds the o-ring in its correct location.

3. At the other end of the check valve body, the spring is

installed over the set of four straight guide lands. When

the spring has been pushed to the correct location, the

check valve body is designed to hold the end of the

spring in position: be sure that the spring is not loose

before continuing with this installation.

4. Install the assembled check valve body/o-ring/spring

in the delivery port so that the o-ring rests on its seat

and the free end of the spring is visible.

5. Grease the adapter and the remaining larger o-ring and

install it onto the tting.

6. Position the governor gasket, then insert the governor

mounting bolts through the governor and tighten (to

125 in-lbs). Note: Do not replace with a standard

compressor/governor gasket.

7. Re-attach line to the governor.

8. Before placing vehicle back into service, check to see

that the system pressure now builds to full operational

pressure.

Log-on and Learn from the Best

On-line training that's available when you are 24/7/365.

Visit www.brake-school.com.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16

Pas de commentaire

BENDIX SD-08-2418 Manuel d'utilisateur Page 11