BENDIX BW2000 Manuel d'utilisateur télécharger pdf (Page 16)

5.3 Wear Limits of Pads and Rotors

Rotors

Measure thickness at the thinnest point. Avoid measu-

ring near the edge of the disc as a burr may be pre-

sent.

A = Rotor thickness (new condition) 1.77in. (45mm)

B = Rotor thickness (worn) 1.46in. (37 mm), Disc must

be replaced

C = Overall thickness of Pad (new) 1.18in. (30mm)

D = Backplate 0.35in. (9mm)

E = Minimum thickness of friction material 0.08in. (2mm)

F = Minimum allowed thickness in worn condition

for backplate and friction material 0.43in. (11mm)

(replacement of Pads necessary).

If wear dimension B ≤ 1.53in. (39 mm) Rotor should be

replaced together with Pads.

Wear dimension B = 1.46in. (37 mm) must not decrease. Minimum allowable thickness B=1.46in. (37 mm)

CAUTION!

Stay within the Rotor and Pad Wear Limits

Pads

The thickness of the Pads must be checked regularly

dependent on the usage of the vehicle.

The Pads should be checked to adhere to any applicable

legal requirements that may apply.

If no Wear Indicator has been connected, check for

wear at least every 3 months.

If friction material is less than 0.08in. (2mm) (see E), the

Pads must be replaced.

CAUTION!

These recommendations must be followed for proper brake performance.

M+P-KN-002

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 35 36

Pas de commentaire

BENDIX BW2000 Manuel d'utilisateur Page 16