BENDIX BW2000 Manuel d'utilisateur télécharger pdf (Page 28)

9 Guide Pin Bushing replacement

(for “Axial- and Radial Disc Brake”)

Remove Caliper (see Section 10.1)

Remove Sleeve (5) and inner Boot (9) (see Section 8).

9.1 Brass Bushing (7) replacement

Remove old Sleeve (5).

Pull out Bushing (7) with Tool (D) (Order No. II19254).

If Caliper has no groove (see arrow)

(Note: Groove is always located on the

inboard side)

Pull in new Brass Bush (7) with Tool (D).

If Caliper has a groove:

Pull in new Brass Bush (7) with Tool (D).

To prevent longitudinal displacement, use

Tool (F) (Order No II36797) to create

dents in bushing.

Check contact area of Brass Bushing (7) for burrs.

Remove burrs.

Grease Bushing with white Grease RENOLIT HLT2

(Order No II14525).

Insert new Sleeve (5).

Note:

The Guide Pins Kit contains new Sleeves (4) & (5)

and new Caliper Bolts (39) & (40) (see Section 1.2

and 1.4).

M+P-KN-030

VF 00127/16

9.2 Rubber Bushing (6) replacement

Remove old Sleeve (4)

Pull Rubber Bushing (6) out of bore.

Check bore for corrosion, clean, if necessary coat bore

with Corrosion protection paint (e.g. Zinc spray).

Note:

Grease new Rubber Bushing (6) inside and outside with

green Grease SYNTHESO GL EP 1 (Order No

II32793).

VF 00127/17

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 34 35 36

Pas de commentaire

BENDIX BW2000 Manuel d'utilisateur Page 28