BENDIX BW2000 Manuel d'utilisateur télécharger pdf (Page 32)

M+P-KN-036

11 Carrier replacement

(for Axial- and Radial Disc Brake)

Remove Caliper (see Section 10.1).

Remove Carrier (2) from axle.

Clean axle contact area.

Bolts are not supplied by Bendix. Attach the new

Carrier with new bolts from the truck manufacturer.

Attach the Caliper (see Section 10.2)

Clamping device

Direction

of pressure

FD00110EN

FD00112

Assemply on the Caliper and Carrier removed

from the axle:

IMPORTANT!

Special threaded Screw (40) and Steel

Cap (10a) as well as the O-Ring (31a)

must be renewed whenever Screw (40)

has been removed.

Put the Caliper on the Carrier.

Screw-in Caliper Bolts (39 and 40) and tighten to

210

+18

ft. lbs. (285

+25

Nm).

Check the position of the Inner Boot (9) on the

Sleeve (5).

Check that the Caliper slides easily.

In the exposed clamping (e.g. vice), press the Caliper

against the Carrier as far as possible. The Inner Boot

(9) must be in compressed condition to prevent

air being trapped inside of the Cap.

Assembly of the Steel Cap (10a) can now be

carried out as in Section “ Assembly at the Vehicle“.

Check Adjuster (Section 5.2).

IMPORTANT!

Replace the Rubber

Boot (10) by the Steel Cap (10a) when

replacing the Sleeve (5), the

O-Ring (31a) and the Screw (40)

at the same time. Replace only on the

recommendation of the Axle or Vehicle

manufacturer. On SB 6... (19.5“) only

permissible after manufacturing date

A0026. (see type plate).

1 2 ... 27 28 29 30 31 32 33 34 35 36

Commentaires sur ces manuels

Pas de commentaire

BENDIX BW2000 Manuel d'utilisateur Page 32

Commentaires sur ces manuels

Produits connexes et manuels pour Non BENDIX BW2000