1®SD-05-4630Bendix® Versajust™ Automatic Slack AdjusterDESCRIPTIONThe Bendix® Versajust™ automatic slack adjuster is designed for use on cam-actuated

2of the Versajust slack adjuster toward the released position causes the link to rotate the pinion. The anti-reverse spring prevents counterclockwise

3A. With the brake chamber in the released position, place a square (or an equivalent object) so that one edge is parallel to the actuator push rod,

4environmental conditions, an application of anti-seize compound to both the camshaft and worm gear spline may facilitate later slack removal.INSTALLA

53. Measure the brake actuator push rod stroke while making an 80-90 psi service brake application. Actuator push rod strokes should not exceed the

6BRAKE MAINTENANCE INSPECTIONNote: Make certain the vehicle has been prepared according to the instructions under the heading GENERAL SAFETY GUIDELINE

7CLEANING AND INSPECTION1. Inspect the worm gear camshaft splines for damage. If damaged, replace the Versajust slack adjuster.2. Clean and inspect

8The Bendix® Versajust™ Slack Adjuster Troubleshooting ChartSymptom Cause Remedy1. Brake Actuator stroke is too long. WARNING: Automatic slack adjus