BENDIX TCH-007-001 Manuel d'utilisateur télécharger pdf

Technical Bulletin

Bulletin No.: PRO-07-01 Effective Date: 9/5/77 Cancels: PRO-07-01 dated 11/10/76 Page: 1 of 7

Subject: OBSOLESCENCE 3/8” AND 7/16” I.D. HOSE “SHORT”

FITTINGS

Effective October 1, 1977, this will announce the obsolescence of the “Short” hose fitting

(Ref. Fig. 1) and nut (Ref. Fig. 2). The “Short” sleeve will remain available under piece

numbers 292615 for 3/8” I.D. hose and 292753 for 7/16” I.D. hose. This will provide

availability of the “Short” sleeves for use with the “Short” nuts in the field. The “Old”

design “Long” fitting body, nut and sleeve again will be the standard H.V.S.G. hose fitting

and will retain their previous piece numbers.

1 2 3 4 5 6 7

Technical BulletinBulletin No.: PRO-07-01 Effective Date: 9/5/77 Cancels: PRO-07-01 dated 11/10/76 Page: 1 of 7Subject: OBSOLESCENCE 3

Page 2

Page 3

Page 4

INTERCHANGEABILITYCombinations of new and old design components can be intermixed except that the olddesign sleeve cannot be used with the new design

NEW DESIGN SLEEVEFIG. 5Must be installed with slots toward nut.

Page 6

HOSE ASSEMBLY INSTRUCTIONS1. Determine length of hose and cut to length.2. Place fitting body in soft jaw vice. Install nut, then sleeve on hose.

Page 7

HOSE ASSEMBLY (WITHOUT SWIVEL END)INSTALLATION INSTRUCTIONSNOTE: It is recommended that in such installations where two (2) stationarycomponents are

Pas de commentaire

BENDIX TCH-007-001 Manuel d'utilisateur