BENDIX GEN 4 GEN 5 ABS Guide de l'utilisateur Page 10

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 16
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 9
10
Installation Test
Installation test allows the technician to verify the
installation of the ECU and system components.
NOTE: In order for the installation test to run the
technician will need to acknowledge the warning
regarding that the vehicle must be parked on level
surface.
Additionally, that ACom
Diagnostics installation
test provides a check of the ABS components with
technician input. Please note that the installation test is
intended as a tool to assist the quality control process
at the vehicle manufacturer. However, this test should
not be relied on as the sole validation check of proper
brake system installation. The vehicle manufacturer
must ensure appropriate process controls are in place
in the manufacturing process to completely validate the
vehicle brake system prior to vehicle shipment.
Figure 28
Customize
The customize screen allows the technician to
customize some of the features in the installation test
like:
Check mark next to a test means that the test will
be performed
Mandatory tests are in gray, optional tests are in
black
Re-arranging test order
Save report in TXT or HTML format
Save report using VIN as fi lename
Folder to save report
Always ask for folder and fi lename
Wheel Speeds in either MPH or RPM
Not allowing the next test to be run if the previous
test failed
Confi rmation if service brake is applied
Installation Test requirements
The following chart indicates which tests are available
for an ECU. If there is a YES next to the test name, that
speci c test is required to be run in order to complete
the installation test. If there is a NO next to the test
name, that speci c test is not required to be run in
order to complete the installation test. If there is an N/A
next to the test name, this indicates that the ECU does
not support that test and that test will not appear in
the installation test list. For the Wheel speed sensors,
at least one of the two sensor tests is required to be
run, indicated by the word “ONE” in the chart. Bendix
recommends that the sensor test be run, although the
simple sensor test is an option.
Installation
Test
ADV ADV MC MV MV MC
ECU
Information
YES YES YES YES
Installation
Angle
YES YES N/A N/A
Axle Load YES YES NO NO
S-C
Sensor or
Simple
ONE ONE ONE ONE
S-D
Sensor or
Simple
ONE ONE ONE ONE
S-E
Sensor or
Simple
N/A ONE N/A ONE
S-F
Sensor or
Simple
N/A ONE N/A ONE
P21
Modulator
YES YES YES YES
P22
Modulator
N/A YES N/A YES
Pressure
Sensor
YES YES YES YES
Battery
Voltage
NO NO NO NO
ABS
Indicator
Lamp
NO NO NO NO
AUX I/O NO NO NO NO
Scratch
Pad
YES YES YES YES
Additionally, tests in gray text must be performed and
tests in black text are optional.
Figure 29
Vue de la page 9
1 2 ... 5 6 7 8 9 10 11 12 13 14 15 16

Commentaires sur ces manuels

Pas de commentaire