BENDIX BW2771 Manuel d'utilisateur télécharger pdf (Page 44)

General Information

Appendix 3 continued

Positive Azimuth Adjustment (FLR too far to the Right)

If the alignment function shows a negative value, then the FLR is adjusted too far to the right, when looked at from the driver's seat. The

radar needs to be adjusted to the driver's left. To accommodate this, adjust the horizontal alignment screw, by turning it in a counter-

clockwisedirection,whenviewedfromthefrontofthevehicle.Eachfullrotationofthealignmentscrewadjustsforapproximately0.2°of

azimuthpositionfromthealignmentfunction.Forexample,iftheazimuthpositionwas-0.5°,thenthealignmentscrewshouldbeadjusted

/2 turns counter-clockwise.

After adjustment of the FLR, perform the calibration procedure again to verify proper alignment.

1 2 ... 39 40 41 42 43 44 45 46 47 48 49 ... 53 54

Pas de commentaire

BENDIX BW2771 Manuel d'utilisateur Page 44