BENDIX TCH-001-021 Manuel d'utilisateur télécharger pdf

Technical Bulletin

Bulletin No: PRO-01-21 Effective Date: 5/15/81 Cancels: NA Page: 1 of 1

Subject:

COMPRESSOR CRANKSHAFT NUT TORQUE

New and remanufactured Bendix compressors are not always furnished with a crankshaft nut.

Some O.E. vehicle manufacturers install their own special nut to mount drive components on the compressor

crankshaft. In these cases we do not furnish a nut with the compressor. A nut of this type must be reused when the

compressor or drive components are replaced.

It is important to torque the crankshaft nut properly. Regardless of the type of crankshaft nut, torque should not

exceed 120 foot pounds.

When installing a castellated nut, torque to 90 foot pounds and check for cotter pin alignment. If the nut is not

aligned with the crankshaft hole, incrementally raise the torque to the maximum 120 foot pounds until the

crankshaft hole and nut align. DO NOT BACK OFF NUT TO ALIGN. If the hole and nut cannot be aligned

within the 90 to 120 foot pound range, a new nut must be used.

Technical BulletinBulletin No: PRO-01-21 Effective Date: 5/15/81 Cancels: NA Page: 1 of 1Subject:COMPRESSOR CRANKSHAFT NUT TORQUENew and remanufact

Pas de commentaire

BENDIX TCH-001-021 Manuel d'utilisateur